Refinishing Hardwood Floors – When Is It Time?

When hardwood flooring get dull and listless, they are able to remove from the value and look of the house they once put into. In case you are like most people in this troubled economy, you are searching for ways to spend less and biting off a huge bill for a floor refinisher just isn’t something you can definitely afford at this time. However, you also can’t afford to let the floors degrade. It is time to bring them back to life with a DIY hardwood floor refinishing project. Yes, you can refinish your whole hardwood floor yourself however it is a good idea that at certain stages you have help.

An important thing to do is clear out each room that you’re going to be working in. Moving things from one room to the next can take up valuable time and can also delay the completion of the project quite significantly. You’re better off renting a small storage container than you are attempting to hustle everything from one room to another location as you try to complete the project. After you have everything out of the rooms, it is time to check the flooring for any bad pieces of molding, floor planks and nails which may be come up a bit over the years.

(C) Gimme the Good Stuff

(C) Gimme the Good Stuff

Dull and dilapidated wood flooring not only looks ugly however it is hard to clean also. Nevertheless, not all wood flooring calls for total refinishing and just a mop of cloth and water would bring back its sheen. This could be tested by spilling some water on the affected area; if the water forms small beads, then the polish has not yet lost its protective coating and just a swipe of wet cloth is sufficient. However, if water percolates in to the floor and turns darker in color, it signifies that the polish has lost its protective coating and also the flooring needs refinishing.

The very first thing you must do is sanding. You need to use an industrial floor sander to sand down the floor. You will likely must rent this. Most likely you will have to buy the sandpaper. The wood must be sanded in the direction of the grain many times using different types of sandpaper every time. Then it should be cleaned and sanded again before it’s finished and stained. It’s a lengthy process. If you decide to complete the task yourself, you’ve got a lot of hard work ahead of you.

After the sanding is finished it is time to apply your stain. When you find yourself ready to apply the stain and finish, put on a mask and ensure the area is well ventilated. The fumes could get a little overwhelming at times and you also do not want any moisture to build up in the room. This tends to make sure that they both dry quickly and properly. The easiest method to apply stain is with a rag. It will prevent brush marks as well as lets you rub the stain into the wood.